The Fire-Lite MS-9600 is a compact, cost-effective, intelligent addressable fire alarm control panel with a capacity of 318 addressable Fire-Lite devices on one Signaling Line Circuit (SLC) or a total of 636 addressable points with an optional second loop (SLC-2). An optional 14.4K Baud modem (DACT-UD) is available for remote site upload/download and/ or remote monitoring.

Each Signaling Line Circuit (SLC) loop supports up to 159 addressable detectors including photoelectric, photoelectric with heat, ionization, photoelectric duct, fixed heat, fixed heat with rate-of-rise, and fixed high-heat detectors. It also supports up to 159 addressable modules including monitor (twowire detector, normally open devices), dual-monitor functions (two monitor circuits from one module, two addresses used), control (for Notification Appliance Circuits), and relay (two Form-C) modules. The panel uses surface-mount technology and is designed for ease of installation, programming, and maintenance. It features the latest in advanced fire protection technology, including maintenance alert and automatic detector test functions.

The SD355 and SD355T addressable, low-profile plug-in photoelectric detectors use a state-of-the-art photoelectric sensing chamber with communications to provide open area protection and are used exclusively with Fire�Lite\'s MS-9200, MS-9200UD, and MS-9600 Addressable Fire Alarm Control Panels (FACPs). The SD355T adds thermal sensors that will alarm at a fixed temperature of 135�F (57�C).

Since these detectors are addressable, they will help emergency personnel quickly locate a fire during its early stages, potentially saving precious rescue time while also reducing property damage. Two LEDs on each sensor light to provide a local, visible sensor indication. Remote LED annunciator capability is available as an optional accessory (P/N RA400Z).

Features: SLC loop: Two-wire loop connection. Unit uses base for wiring. Addressing: Addressable by device. Direct Decade 01 � 99 (MS-9200, MS-9200UD) and 01 � 159 (MS-9600) entry of address. Architecture: Unique single-source, dual-chamber design to respond quickly and dependably to a broad range of fires. Sleek, low-profile design. Integral communications and built-in type identification. Built-in tamper-resistant feature. 

The Fire-Lite Alarms BG-12LX is a state-of-the-art, dual-action (i.e., requires two motions to activate the station) pull station that includes an addressable interface (mounted inside) for Fire-Lites addressable MS-9200, MS- 9200UD, and MS-9600 fire alarm control panels. Because the BG-12LX is addressable, the control panel can display the exact location of the activated manual pull station. This leads fire service personnel quickly to the location of the alarm.·

Aesthetically pleasing, highly visible, dual-action design. Meets ADA 5 lb. maximum pull force. Easily operated (dual-action). Attractive shape and textured finish. Mounts, semi-flush, to a standard single-gang (2.125\"[5.3975 cm] minimum depth), double-gang, or 4\" (10.16cm) square electrical box. When the handle latches in down position, the word \"ACTIVATED\" appears at the top of the handle in bright yellow to clearly indicate the station has been operated. Key/lock reset; needs only a 1/4-turn to lock/unlock. Includes Braille text on station handle. aptive screw terminals wire-ready for easy connection to SLC loop (accepts up to 12 AWG/3.25 mm² wire). Optional trim ring (BG-TR). Meets UL 38, Standard for Manually Actuated Signaling Boxes. 

The SpectrAlert Advance series of notification appliances is designed to simplify installations, with features such as plug in designs, instant feedback messages to ensure correct installation of individual devices, and 11 field-selectable candela settings for wall and ceiling strobes and horn/strobes.

The SpectrAlert Advance series includes outdoor notification appliances. Outdoor strobes and horn/strobes (two wire and four wire) are available for wall or ceiling. Outdoor horns are available for wall only. All System Sensor outdoor products are rated between minus 40 degrees Fahrenheit and 151 degrees Fahrenheit in wet or dry applications. 

Electrically compatible with existing SpectrAlert products.  Automatic selection of 12- or 24-volt operation at 15 and 15/75 candela. Plug-in design.  Field selectable candela settings on wall and ceiling units: 15, 15/75,

30, 75, 95, 110, 115, 135, 150, 177, 185.  Same mounting plate for wall- and ceiling-mount units. Shorting spring on mounting plate for continuity check before installation. Tamper resistant construction. 

The SpectrAlert Advance series of notification appliances is designed to simplify installations, with features such as plug in designs, instant feedback messages to ensure correct installation of individual devices, and 11 field-selectable candela settings for wall and ceiling strobes and horn/strobes.

The SpectrAlert Advance series includes outdoor notification appliances. Outdoor strobes and horn/strobes (two wire and four wire) are available for wall or ceiling. Outdoor horns are available for wall only. All System Sensor outdoor products are rated between minus 40 degrees Fahrenheit and 151 degrees Fahrenheit in wet or dry applications. 

Electrically compatible with existing SpectrAlert products.  Automatic selection of 12- or 24-volt operation at 15 and 15/75 candela. Plug-in design.  Field selectable candela settings on wall and ceiling units: 15, 15/75,

30, 75, 95, 110, 115, 135, 150, 177, 185.  Same mounting plate for wall- and ceiling-mount units. Shorting spring on mounting plate for continuity check before installation. Tamper resistant construction. 

ADEMCO\'s 5809 wireless fixed heat and rate-of-rise temperature sensor offers expanded fire detection and installation flexibility. It is ideal for hard to wire locations and applications that require more than smoke detection. With no wires to run, the 5809 is fast and easy to install. The 5809 combines both rate-of-rise and fixed temperature sensors. Fires typically cause a rapid rise in temperature in the surrounding area. The 5809\'s rate-of-rise thermostat senses the rise in temperature and signals an alarm if the increase is 15\' or more per minute. A built-in fixed temperature sensor will also signal an alarm if the environmental temperature rises above 135F. Features: Contains a built-in transmitter which can send alarm, supervisory and battery condition messages to the system\'s receiver/control unit Powered by a three-volt lithium battery. If the battery voltage gets too low, the 5809 sends a low battery signal to the control panel  Features a tamper switch, which causes a trouble signal to be sent to the control if the unit is removed from the mounting base UL Listed for Commercial (when using 5881EH Receiver) or Residential applications